TRUEBYPASS
1 x 3PDT stomp

RATE DOUBLER
1 x 10uF 
1 x stomp switch (SPST or greater)

RAMP-UP SAWTOOTH
1 x DPDT flip switch
1 x 220k resistor
1 x Si diode (1N4001 or equiv.)

GAIN
1 x 100k pot (or 10k pot)
1 x knob cover
---the 100k trim pot that's part of the stock kit is not needed

SYMMETRY
1 x 500k linear pot
1 x knob cover
2 x Si diode (1N4001 or equiv.)

AUX LFO (to add to main) SUPERBOARD
(use this list instead of the stock trem list)
1 x battery snap [12BC136]
1 x 1/4" output jack [161-1804]
1 x 1/4" input jack [568-NYS234-3]
4 x 100k pot [31CN501]
2 x 10k pot [31CN401]
2 x 500k pot [31CN505]
8 x knob covers
10 x 1k resistor [291-1k]
2 x 2k7 resistor [291-2.7k]
2 x 100k resistor [291-100k]
7 x 220k resistor [291-220k]
3 x 470k resistor [291-470k]
2 x 1M resistor [291-1M]
2 x 1uF cap [140-XRL25V1]
3 x 10uF cap [140-XRL25V10]
2 x 0.01 cap [140-50Z5-103M]
1 x 330pF cap []
4 x IC sockets [575-993308]
3 x 4558 opamp IC [513-NJM4558D]
1 x 072 opamp IC [511-TL072IN]
1 x 500 trimpot 
2 x round LED [351-5500]
2 x LED clip
1 x superbright red round LED ("red LED")
1 x CdS cell: 5k light, 500k dark (Jameco #202391, or electronic-goldmine #G15177)
1 x stomp switch


AUX LFO (to add to main)--the mini mod board (not the superboard)
3 x 100k linear pot (one is for main board)
2 x knob covers
1 x round LED
1 x LED clip
1 x 470 resistor (for main board)
8 x 1k resistor (2 are for main board)
2 x 220k resistor
2 x 470k resistor
1 x 2k7 resistor
1 x 0.01uF (103) cap
1 x 10uF cap
2 x 4558 dual op-amp IC
2 x 8-pin IC socket
1 x 500 ohm trim pot


AUX LFO (to modulate the main)
1 x 1k linear pot
1 x 100k linear pot
2 x knob covers
1 x CdS cell (<5k dark, >100k light) (Jameco #202391, or electronic-goldmine #G15177)
1 x Rect LED
7 x 1k resistor
2 x 220k resistor
2 x 470k resistor
1 x 0.01uF (103) cap
1 x 100uF cap
1 x 4558 op-amp IC
1 x 8-pin IC socket
1 x round LED
1 x LED clip